Electric Toilets & Kits

Solenoid Valve for 37010 Series Electric Toilets

Where 37010 Series Electric Toilets are installed below the waterline, we recommend installing a loop on the inlet plumbing rising at least 8″ (20cm) above the highest (static or heeled) waterline level, and installing a vented loop fitting at the top of the loop to stop water siphon over the loop and flooding the vessel.

The suction generated by 37010 Series Electric Toilets will open the valve in vented loops, drawing in air and preventing priming. The 37068-2000 Solenoid Valve attaches directly to Jabsco Vented Loops and is wired to the toilet’s on/off switch. It closes whenever the toilet pump is operated and ensures full pump priming.

General Pumping Advice, Good Practice and Support Marine Toilets Wizard Rule Bait/Livewell Pumps Advice and Support Rule Bait/Livewell Pumps Installation Guide Rule Bilge Pumps Advice and Support Troubleshooting a Pressurised Water System Warranty Information