I. GENERAL FIELD SERVICE

1. System Preparation
2. Removing the Conduit Box Cover
3. Disconnect the Coupler from the Pump Shaft
4. Separate the Motor from the Bearing
   Assembly
5. Removing and Replacing The Coupler

II. MOTOR MOUNT SERVICE

1. Motor Mount Replacement
2. Inspect Motor Mount tear and Damage
3. Removing the Motor Mount – Outer Ring
4. Removing the Motor Mount – Inner Ring
5. Replacing the Motor Mount
6. Completing Motor Mount Service

III. BEARING ASSEMBLY SERVICE

1. Removing the Bearing Assembly
2. Disengage the Bearing Assembly
3. Removing the Impeller
4. About the Impeller, Washer and Spring
5. Removing the Mechanical Seal
6. Removing the Oil Cover
7. Removing the Oil Wick
8. Beginning Disassembly of the Front Bearing
9. Removing the Front Bearing
10. Examine the Bearing and Pump Shaft
11. Cleaning the Shaft’s Copper Sleeve
12. Beginning the Reassembly of the Bearing
13. Securing the Front Bearing
14. Installation of the Oil Wick
15. Replacing the Mechanical Seal
16. Clean the Seat of the Mechanical Seal
17. Installing the Mechanical Seal
18. Final Assembly of the Seal
19. Replacing the Impeller

1. Inspect and Clean the pump Body
2. Installing a new Pump Body Gasket
3. Aligning the Bearing Assembly
4. Attaching the Coupler
5. Installing the Motor

V. RESTARTING THE SYSTEM

1. Filling and Venting the System
2. Connecting the Electrical Power

VI. SPECIAL CONSIDERATIONS

1. Proper Oiling Procedures
2. Bronze Body Boosters

PUMPING SYSTEM TROUBLE ANALYSIS GUIDE

B&G FACTORY GUARANTEED REPLACEMENT PARTS